Good Earth Lighting BO1065-WHG-06LF6-E

Ecolight 6-inch LED Motion Utility Light

Model: BO1065-WHG-06LF6-E | Brand: Good Earth Lighting

Introduksjon

This manual provides comprehensive instructions for the installation, operation, and maintenance of your Ecolight Battery-Operated 6-inch LED Dual Lens Motion Utility Light. Please read this manual thoroughly before using the product to ensure proper function and safety.

Sikkerhetsinformasjon

  • Sørg for at batteriene er satt inn med riktig polaritet.
  • Ikke bland gamle og nye batterier, eller forskjellige typer batterier.
  • Ta ut batteriene hvis lyset ikke skal brukes over lengre tid.
  • This product is designed for dry locations only. Avoid exposure to water or high humidity.
  • Oppbevares utilgjengelig for barn.

Pakkeinnhold

Kontroller at alle komponenter er til stede før installasjon:

  • 1 x Ecolight 6-inch LED Motion Utility Light
  • 3 x AA-batterier (inkludert)
  • 4 x Small Damage-Free Picture Hanging Command Strips by 3M
Ecolight 6-inch LED Motion Utility Light packaging showing contents
Figure 1: Product packaging illustrating the included components.

Oppsett og installasjon

The Ecolight Motion Utility Light is designed for easy, flexible, and damage-free mounting using the included 3M Command Strips. No wiring is required.

Step 1: Prepare the Light

  1. Fjern bakdekselet på lyset.
  2. Locate and remove the clear plastic tab from the battery compartment. This activates the included AA batteries.
  3. Sett på bakdekselet.
Topp view of the Ecolight 6-inch LED Motion Utility Light
Figur 2: Øverst view of the light, showing the motion sensor and light lenses.

Trinn 2: Klargjør monteringsoverflaten

  • Choose a clean, dry, and smooth surface for mounting.
  • Clean the surface with rubbing alcohol and a clean cloth. Allow it to dry completely. Do not use household cleaners.

Step 3: Apply Command Strips

  1. Separate the two interlocking strips from each pair.
  2. Firmly press two strips together until they click. Repeat for all four strips.
  3. Remove the green liner from one side of each paired strip.
  4. Apply these strips to the designated flat areas on the back of the light. Press firmly.
  5. Remove the remaining liner from the exposed side of each strip.

Step 4: Mount the Light

  • Align the light with the prepared surface.
  • Press the light firmly against the surface for 30 seconds to ensure strong adhesion.
Ecolight 6-inch LED Motion Utility Light installed under a kitchen cabinet
Figure 3: The utility light installed under a cabinet, providing illumination.

For a visual guide on installation and removal, please refer to the official product video:

Video 1: Official installation and removal guide for the Ecolight Motion Utility Light. This video demonstrates the steps for setting up and safely removing the light using Command Strips.

Bruksanvisning

The Ecolight Motion Utility Light features motion-activated operation and an auto-off timer for energy efficiency.

  • Bevegelsesaktivering: The integrated 100-degree Passive Infrared (PIR) sensor detects motion up to 12 feet away. The light will only activate when it is dark and motion is detected, conserving battery life.
  • Timer for automatisk avstengning: After the light activates and no further motion is detected, it will automatically turn off after 30 seconds.

Vedlikehold

Batteribytte

When the light output diminishes, it is time to replace the batteries.

  1. Carefully remove the light from its mounting surface. If using Command Strips, follow the removal instructions (pull tab straight down slowly).
  2. Fjern bakdekselet på lyset.
  3. Replace the three (3) AA batteries with new ones, ensuring correct polarity (+/-).
  4. Sett på bakdekselet.
  5. Re-mount the light using new Command Strips if necessary, following the installation steps.

The light is rated for 52 hours of illumination on a full battery charge.

Feilsøking

Problem Mulig årsak Løsning
Lyset tennes ikke. Batteriene er tomme eller feil installert. Skift batteriene, og sørg for at polariteten er riktig.
Lyset tennes i dagslys. Sensor is detecting insufficient ambient light. Ensure the light is installed in an area that is sufficiently dark for motion activation.
Light does not detect motion reliably. Sensor obstructed or outside detection range. Clear any obstructions from the sensor. Ensure motion occurs within 12 feet and 100 degrees of the sensor.
Lyset slår seg av for raskt. No continuous motion detected within 30 seconds. This is normal operation. The light is designed to turn off after 30 seconds of no detected motion to conserve battery life.

Spesifikasjoner

  • Modellnummer: BO1065-WHG-06LF6-E
  • Dimensjoner: 6 x 2.5 x 1.1 tommer (L x B x H)
  • Varevekt: 6.4 unser
  • Strømkilde: Battery powered (3 x AA batteries, included)
  • Voltage: 4.5 volt (DC)
  • Wattage: 6 watt
  • Type pære: LED
  • Lysstrøm: 80 Lumen
  • Fargetemperatur: 4000K (Bright, neutral white light)
  • Bevegelsessensor: 100-degree PIR sensor, detects motion up to 12 ft.
  • Timer for automatisk avstengning: 30 seconds (after no motion detected)
  • Lamp Liv: Opptil 30,000 timer
  • Batterilevetid: Approximately 52 hours of illumination on a full charge
  • Installasjonsmetode: Wall-mounted (with included 3M Command Strips)
  • Bruk: Bare tørt sted
  • Materiale: Plast
  • Farge: Hvit

Garanti

This Ecolight Motion Utility Light comes with a 6 års begrenset garanti. For details regarding warranty coverage and claims, please refer to the product packaging or contact Good Earth Lighting customer support.

Støtte

For further assistance, technical support, or inquiries, please contact Good Earth Lighting customer service. Contact information can typically be found on the product packaging or the manufacturer's official webnettstedet.

Produsent: God jordbelysning

Webnettsted: Good Earth Lighting Store on Amazon

© 2024 Good Earth Lighting. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.