Baseus BS-CH001 10000mAh Car Jump Starter and Power Bank User Manual

Introduksjon

The Baseus BS-CH001 is a versatile device designed to provide emergency jump-starting for 12V vehicles and serve as a portable power bank for charging electronic devices. With a 10000mAh capacity and a peak current of 1000A, it offers a reliable solution for unexpected car battery issues and on-the-go power needs. This manual provides essential instructions for safe and effective use.

Note: Product images and videos are not included in this manual due to a discrepancy between the product description and the available media assets.

Pakkeinnhold

Vennligst sjekk pakken for følgende varer:

• 1 x Baseus Car Jump Starter
• 1 x Smart Jump Starter Clamp Cable (with red and black alligator clips)
• 1 x USB til Type-C ladekabel

Nøkkelfunksjoner

• Høy ytelse: 10000mAh capacity, 12V start voltage, 500A starting current, and 1000A peak current.
• Multifunksjonell: Acts as both a car jump starter and a portable power bank.
• Reliable Starts: Capable of starting a car up to 50 times on a single full charge.
• Integrert skjerm: Digital screen shows the remaining battery level of the jump starter.
• Ekstrem temperaturmotstand: High-performance polymer battery cells ensure operation in very low and high temperatures.
• Avansert sikkerhet: Features 9 levels of protection including overcharge, voltage stabilization, short circuit, over-discharge, reverse connection, and over-temperature protection.
• Lav standby-strøm: Retains up to 85% of stored energy after one year of non-use.
• Innebygd LED-lys: Can be used as an emergency flashlight.
• Bærbar: Compact size and technical parameters allow it to be carried on an airplane.

Sikkerhetsinformasjon

Les alle sikkerhetsadvarsler og instruksjoner før du bruker dette produktet. Unnlatelse av å følge disse instruksjonene kan føre til elektrisk støt, brann og/eller alvorlig skade.

• Ikke demonter, modifiser eller reparer enheten.
• Ikke utsett enheten for regn eller fuktighet.
• Do not use the device if the battery clamps eller kabler er skadet.
• Sørg for riktig polaritetstilkobling (rød kabel)amp til positiv, svart klamp to negative) to avoid short circuits.
• Oppbevares utilgjengelig for barn.
• Ikke start et frossent batteri.
• Ikke koble den positive og negative clamps sammen.
• Bruk enheten i et godt ventilert område.
• Remove the jump starter from the car battery immediately after starting the vehicle.
• Oppbevar enheten på et kjølig, tørt sted når den ikke er i bruk.

Setup: Charging the Jump Starter

Before first use, fully charge the jump starter. It is recommended to charge the device every 3-6 months to maintain battery health, even when not in use.

1. Connect the provided USB to Type-C charging cable to the Type-C input port on the jump starter.
2. Connect the other end of the USB cable to a suitable USB power adapter (e.g., 5V/2.4A, not included).
3. Det digitale displayet viser ladeprosessen. Lad til displayet viser 100 %.
4. Når den er fulladet, koble fra ladekabelen.

Operating Instructions: Car Jump Starting

Følg disse trinnene nøye for å starte kjøretøyet med startkabler:

1. Step 1: Connect the Smart Clamp Kabel

   Insert the smart jump starter clamp cable into the EC5 interface of the Baseus jump starter. The flashing red and green lights on the clamp indicate it's ready for connection to the car battery.

2. Trinn 2: Koble til bilbatteriet

   Open your car's hood. Connect the red positive (+) clamp to the positive (+) terminal of your car battery. Connect the black negative (-) clamp to the negative (-) terminal of your car battery. Ensure a secure connection.
3. Step 3: Start the Vehicle

   Return to your car and start the engine. If the car does not start immediately, wait a few seconds and try again. Do not crank the engine for more than 3 seconds at a time, and wait at least 30 seconds between attempts.

4. Trinn 4: Koble fra

   Once the car engine starts, immediately remove the smart jump starter clamp cable from the car battery terminals, then disconnect it from the jump starter. Do not drive with the jump starter connected.

Operating Instructions: Power Bank Function

The Baseus BS-CH001 can also be used to charge your electronic devices.

1. Connect your device's charging cable (e.g., USB to Type-C, USB to Lightning) to the USB output port on the jump starter.
2. Koble den andre enden av kabelen til den elektroniske enheten din.
3. The jump starter will automatically begin charging your device. The digital display will show the remaining power.
4. Once charging is complete, disconnect your device and the cable.

Vedlikehold

• Rengjør enheten med en tørr, myk klut. Ikke bruk slipende rengjøringsmidler eller løsemidler.
• Oppbevar starthjelpen på et kjølig og tørt sted, unna direkte sollys og ekstreme temperaturer.
• For optimal battery life, fully charge the device at least once every 3-6 months.
• Hold clamp cables clean and free from corrosion.

Feilsøking

Spesifikasjoner

Garanti og støtte

This product comes with a standard manufacturer's warranty. For detailed warranty information, please refer to the warranty card included in your product packaging or visit the official Baseus website. For technical support, troubleshooting assistance, or to inquire about replacement parts, please contact Baseus customer service through their official channels.

Merk: Produktdataene oppga ingen spesifikk garantiperiode eller kontaktinformasjon for kundestøtte. Se produsentens offisielle ressurser.