Dickson WiZARD2 Replaceable Sensor Logger User Guide

Dickson WiZARD2 Replaceable Sensor Logger

Spesifikasjoner

Viktig melding
Please follow the steps below before using your chart recorder for the first time.

Set Chart

1. Trykk MENU to ganger.
2. Use UP or DOWN buttons to scroll through available chart number options (chart options determined by attached sensor).
3. Trykk MENU for å lagre.
4. Default Unit of Measure will display. Use UP or DOWN buttons to scroll and select alternate (option may not display depending on chart selected).
5. Trykk MENU for å lagre.

Still inn tid

1. Trykk på MENY.
2. ADJ TIME will display. Press and hold UP or DOWN button to rotate chart to the correct time or day/time as referenced by the timing arrow (just below the pen ramp).
3. Trykk MENU for å lagre.
4. Press HOME. Pens will move onto the chart to begin recording.

Operasjon

For å starte driften

1. Fjern den beskyttende pennhetten.
2. Plug the Replaceable Sensor™ firmly into the logger (lower left side of case). Confirm the raised bump on the Replaceable Sensor touches the inside edge of the sensor compartment.
3. Insert Batteries (4 C type) and plug into AC adapter.
4. Install chart. Confirm the chart is aligned on the hub and slid underneath the pen home ramp and chart clip.
5. Press the power button and follow the display prompts to configure. Note: Unit may power on automatically when AC and battery power are applied.

Vanlige spørsmål

What should I do if the unit does not power on?\

Ensure that both the AC adapter is plugged in and the batteries are correctly installed.